Truper CEPEL-4-1/2NX Manual Del Usuario página 20

Chip ejection
• Turn the shavings outlet dial so that the arrow points
towards the planer side where you want shavings to be
expelled.
• You can also connect a workshop dust extracting system
or a household vacuum cleaner into the exhaust. This will
make a safer and cleaner work place.
Planning
• Set the adjustable base onto the work piece surface. The
blades should not make contact with the piece (Figure 1).
• Start the tool and wait for the blades to reach the
maximum speed.
• Holding the tool with both hands, run it smoothly
applying pressure in the front on the auxiliary handle
(Figure 2). The job will be easier if the work piece is
slightly tilted to allow a downwards planning.
• Push the tool beyond the work piece but not leaning
downwards (Figure 3).
• The planning speed and cutting depth determine the
finish quality. To get a rough cut increase the cutting
depth. To get a fine finish diminish the cutting depth and
push the tool slower.
CAUTION An extremely fast pass of the tool may
produce bad quality cuts and will damage the blades or
the motor. If the movement is to slow, you may burn or
damage the cut.
The right advancing speed will be dependent of the type
of material being used and the cutting depth. Before
planning the work piece, make some tests using a piece
of scrap wood to gauge the right speed and the
dimensions of the cut.
WARNING Secure the work piece using clamps to
prevent accidents and defects in the cut.
Bevel Cuts
• For bevel cuts or chamfers, match the work piece edge
with one of the two slots in "V" in the adjustable base.
• Make passes with the planner aligning the notch on the
edge.
8
ENGLISH
Start Up
Shaving
Outlet Selector
Shavings
Exhaust
1
2
3