2. INSTALLATION
2.1 general instructions
This appliance must only be used for the purposes it has been speci cally designed for. This appliance
may be applied, according to its characteristics, performance and heating capacity, to water boilers, steam
boilers, diathermic oil boilers and other utilities, as expressly envisaged by the manufacturer of such. All
other uses are considered improper and thus dangerous.
The appliance may not be opened nor its components tampered with, except for the parts included in the
maintenance operations. The appliance may not be modi ed to alter its per for man ce or use.
If the burner is tted with optional devices, kits or accessories, only original products should be used.
THE BURNER MUST ONLY BE INSTALLED AND ADJUSTED BY QUALIFIED AND SPECIALIST
PERSONNEL, IN COMPLETE COMPLIANCE WITH ALL THE INSTRUCTIONS REPORTED IN
THIS TECHNICAL MANUAL, THE LEGAL STANDARDS IN FORCE, THE PRESCRIPTIONS OF
THE UNI AND CEI STANDARDS AND ANY LOCAL STANDARDS, AND ACCORDING TO THE
RULES OF GOOD PRACTICE.
2.2 installation in the boiler
Place of installation
The room in which the boiler and burner are installed must have openings to the outside according to the
standards in force. If the same room features a series of burners or air inlet devices that can operate at
the same time, the ventilation openings must be large enough for the simultaneous operation of all the
appliances.
The place of installation must be free of in ammable objects or materials, cor ro si ve gas, dust or volatile
substances that, sucked in by the fan, may block the internal tubing of the burner or the combustion head.
The environment must be dry and not exposed to rain, snow or frost.
Fastening to the boiler
1) Insert screw 2 (m8x40) in ange 3.
2) Fasten ange 3 to the boiler using screws 5 (4 ea., m8x20), with the insulating gasket 1 placed in
between.
3) Insert the burner into the boiler ange and fasten it to screw 2 using nut 4.
20
g. 2
Cod. 3540C353 - Rev. 01 - 02/2015
SUN G3 R
GB