Publicidad
SLIDING DOOR HARDWARE - POCKET DOOR
1
PREPARE OPENING
Hmax = Door Height + 3-1/16" • Hmin = Door Height + 2-7/16"
Rough Opening Width = 2 x Door Width + 1"
2
mOuNT FRAmE HARDWARE
• Center track in opening.
• To take advantage of the key-holed slots, be sure there is
a minimum 3/4" gap from the finished opening to the
track. If necessary, track may be cut with a fine tooth saw.
• ImPORTANT: Place hangers loose into track before
securing.
• Using track as template, mark screw locations.
• Drill 3/32" pilot holes and secure with (#8 x 1")
screws. (F)
• To allow future replacement in the field, the screws
installed through the track to the header in the pocket
side must be backed out one half turn after seating
the track.
3
mOuNT DOOR HARDWARE
• Place quick release top mount plates on top of
each door at the distance shown from the
outside edge.
• Using brackets as a template, drill 3/32" diameter
holes and secure with (#8 x 1") screws. (F)
• Secure door bumper as shown.
Opening Width
Largeur de l'overture
Ancho de la abetura
Opening Height
Hauteur Ouverture
Altura Abertura
Pocket
Partie
coulissante
escamotable
Cavidad
(2,5 cm)
Rear
Arriére
Parte trasera
Center
Centre
Centro
#310291_C (1013)
Assembly
Instructions
2-1/16" - 2-11/16"
Door Height
Hauteur Porte
Altura Puerta
(1 cm)
1"
Rear
Arriére
Parte trasera
5-1/2" (14 cm)
(5,2 cm - 6,8 cm)
3/8"
3/4" Min.
(1,9 cm)
Opening
Hauteur
Altura
Front
Avant
Delantera
Publicidad
