Avintage AV22XI Manual De Utilización página 44

1. Incline the wine cooler with 45 degrees, take out right lower hinge's screws and support's screws
with screwdriver (Fig.1).
2. Level the wine cooler, hold the door and take out right upper hinge's screws with screwdriver, then
take out the door, put the door safety, unscrew 2 screws at bottom and remove the reed switch,
then install at top of frame, and take out the location-plate's screws and fix location-plate on the
other side, and rotate door at 180 degree (Fig.2 & Fig.3 & Fig.4).
3. Remove limited block B as per the arrows in picture, then release all the screws on limited block A,
and take away limited block A. Install the limited block A at the right side with screws, then install
limited block B, then fit the door with screws, then fix the support on the lower right side (see Fig.5
& Fig.6 & Fig.7).
4. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is
between 16-32°C (N class marked on the rating plate). If the ambient temperature is above or below
recommended temperatures, the performance of the unit may be affected and it may not be possible
to obtain temperature between 5-20°C.
How to set temperature
This is LCD touch panel.

"Power"
When the indicator light is on, the power for machine is on.

" "
To show the temperature of the internal cooler.

" "
Used to rise the temperature by 1°C.

" "
Used to down the temperature by 1°C.

" "
To control the inner light turn on/off.
Press this button, the light is on, and the light is not controlled by door. Press this button again, the
light is off, and the light is controlled by door.
NOTE: it will take 3 seconds for LED light completely went out after turning off the light.

" "
To control this appliance turn on/off.
Press this button, the power is on and press this button with 3 seconds again, the power is off.
44