Bosch MRC23EVS Instrucciones De Funcionamiento página 26

Ocultar thumbs Ver también para MRC23EVS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BM 2610004573 03-12_BM 2610004573 03-12 6/26/12 7:16 AM Page 26
Preventive maintenance
WARNING
performed by unauthorized
personnel may result in misplacing of
internal wires and components which
could
cause
recommend that all tool service be performed
by a Bosch Factory Service Center or Autho-
rized Bosch Service Station.
BASE CLAMP
If additional clamping force is desired: use a
2.5 mm Allen wrench and turn the set screw
clockwise SLIGHTLY (1/8 turn or less), then
test clamp. Do not over-tighten.
COLLET CHUCK CARE
With the router bit removed, continue to turn
the collet chuck counter-clockwise until it is
free of the shaft. To assure a firm grip,
occasionally blow out the collet chuck with
compressed air, and clean the taper in the
armature assembly shaft with a tissue or fine
brush. The collet chuck is made up of two
component parts as illustrated (Fig. 30); check
to see that the collet is properly seated in the
collet chuck nut and lightly thread the collet
chuck back onto the armature shaft. Replace
worn or damaged collet chucks immediately.
FIG. 30
COLLET
COLLET
NUT
TOOL LUBRICATION
Your Bosch tool has been properly lubricated
and is ready to use. It is recommended that
tools with gears be regreased with a special
gear lubricant at every brush change.
Maintenance
Service
serious
hazard.
COLLET
CHUCK
CARBON BRUSHES
The brushes and commutator in your tool
have been engineered for many hours of
dependable service. To maintain peak
efficiency of the motor, we recommend every
two to six months the brushes be examined.
We
Only genuine Bosch replacement brushes
specially designed for your tool should be
used.
After about 300-400 hours of operation, or at
every second brush change, the bearings
should be replaced at Bosch Factory Service
Center or Authorized Bosch Service Station.
Bearings which become noisy (due to heavy
load or very abrasive material cutting) should
be replaced at once to avoid overheating or
motor failure.
WARNING
the power supply before cleaning or
performing any maintenance. The tool may
be cleaned most effectively with compressed
dry air. Always wear safety goggles when
cleaning tools with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through openings.
Should a significant amount of dust gather in
the motor-to-base 5V electrical connection
track on either the base or motor, the dust can
be removed with a vacuum cleaner,
compressed air or soft brush.
CAUTION
plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
-26-
BEARINGS
Cleaning
To avoid accidents always
disconnect the tool from
Certain cleaning agents
and
solvents
damage

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mrf23evsMrp23evs

Tabla de contenido