Dry Vacuum - Cleaning - KUBOTA 54104 Manual Del Usuario

DRY VACUUM - CLEANING

5
1. Verify that the power cord is disconnected from the outlet.
2. Loosen the locking latches.
3. Pull the supplied cartridge filter on the suction mouth for dry vacuum
cleaning.
4. Insert the suction hose in the hole on the side of the tank. Turn the
hose connector.
5. Connect tube into the floor brush and tighten locking latches on the
cover.
6. Insert the plug into the socket.
7. Press the switch button and the vac will begin to work.
8. While in use you notice the bin is full resulting in significant decreases
in suction power, remove the plug from the electrical outlet and clean
the drum.
9. Unhook the two latches.
10. Remove the power head from the dust drum and remove filter.
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE WALL
OUTLET BEFORE REMOVING THE TANK COVER.
BLOWER VACUUM - CLEANING
Please note:
Figure 1: The top part can be taken over from the barrel cover, with the accessory
blower tube
14.5 Gallon Wet & Dry Vacuum Cleaner with Blower
1 2
6 7
3 4
8 9
ENGLISH
11