Section 4; Before Use; Driveline - breviglieri Super Master 160 Instrucciones De Empleo Y Mantenimiento

▪ After having transported the machine to the desired site and before removing the elements that hold it in place, make sure
that its position is unable to be of danger.
Now remove the ropes and unload the machine from the means of transport in the same way as it was loaded.
▪

SECTION 4

Instructions for use

4.1 BEFORE USE

Before he sets the machine at work, the operator must have read and understood all parts of this manual and particularly
Before beginning work, make sure that the machine is in order, that the lubricating oils are at the right level and that all parts
subject to wear and deterioration are fully efficient. Also make sure that the guards are correctly positioned.
Adjustments and operations required to prepare the machine for work must always be carried out with the machine off

4.1.1 DRIVELINE

The driveline is a mechanical component. When it is operating it can be a source of danger to the physical well-being of
those who work with it. Take the greatest care when carrying out operations that involve the driveline. Carefully read the
instruction manual supplied with the driveline. If you have doubts about the way it operates, if it is without its shields, worn
or broken, replace it with a new driveline that possesses the same characteristics and bears the «CE» mark.
The driveline supplied with the machine is a transmission component which, owing to the particular way in which the ma-
chine is constructed, has a very special configuration. Its main characteristic is its long length. This feature ensures that
the movement is transmitted in all the work positions in which the machine can function. If the length must be adapted,
work with the utmost care so as to keep the telescopic tubes coupled to the maximum extent. With the exception of length
adaptation, it is forbidden to modify the driveline. If this is necessary, contact the
Manufacturer. Take the greatest care when inserting the driveline. Make sure that
it is well locked on both the tractor's PTO and on the machine. Also comply with
the indications in the instruction manual supplied with each driveline. Make sure
that the driveline shield, fastened with the relative chains, is free to turn without
obstruction. Also check the guards on both the tractor and implement. If they are
not in a perfect condition, they must be immediately replaced with new protections.
It is very important for the protective guards to overlap the driveline shields by at
least 5 cm on both sides.
When the driveline is fully extended, in all work conditions, the telescopic tubes must
overlap to at least 1/3rd of their length (A Fig. 4).
When the driveline is fully inserted, the play must be at least 4 cm (B Fig. 4). Contact
super master
WARNING
«Section 2» about safety.
DANGER
and blocked.
DANGER
DANGER
Never modify or adapt the driveline in any way.
- 26 -
Fig. 4