Other Connections; Network Connection - Onkyo HT-R693 Manual Básico

Cut and remove the plastic coating from the end of the
speaker cable, twist the core and connect it to the terminal.
Make correct connection between the unit's jacks and
speaker's jacks (+ to + and - to -) for each channel. If
connection is wrong, a bass sound may become poor due
to reverse phase.
The speaker terminals of the home theater package are colored for
easy identification. Connect a color-coated wire (+) of each speaker
cable to the corresponding speaker terminal of the same color.
Connect a subwoofer by connecting the LINE INPUT jack
to the PRE OUT SUBWOOFER jack as shown in the figure.
Up to two subwoofers with built-in power amplifier can be connected
to this unit. Set the cut-off filter selection switch of the subwoofer to
DIRECT, if applicable. If the subwoofer does not have a cut-off filter
selection switch but has a cut-off frequency adjusting dial, turn it to
the maximum frequency. If your subwoofer does not have built-in
power amplifier, you can connect a power amplifier between the unit
and the subwoofer.
Note
Short-circuiting the + cable and - cable or contacting the
cable core to the rear panel of the unit may cause failure.
Also do not connect two or more cables to one speaker
terminal or one speaker to several terminals.
When using commercially available banana plugs, tighten
the speaker terminals to the end and then insert the
banana plugs. Do not insert the core of speaker cable
directly into the hole for banana plug of speaker terminal.
(North American model)
6
3

Other connections

AM/FM antenna connections
Connect the antennas to listen to AM/FM broadcast. When
listening to the broadcast for the first time, adjust the
antenna position and orientation to get the best reception.
AM loop antenna (supplied)
Indoor FM antenna
(supplied)
Fix with a tack on
the wall.
(North American model) (European model)
Assemble the AM loop antenna (supplied).
Step 1: Connections

Network connection

You can enjoy Internet radio and DLNA by connecting
the unit to LAN. The unit can be connected to the router
with an Ethernet cable or to the wireless LAN router with
Wi-Fi connection. In case of wired connection, connect the
Ethernet cable to the ETHERNET port. For Wi-Fi setup, see
"4th Step : Network Connection" of "Step 2: Setting Up".
Internet radio
Router
Headphones connection
or ø 6.3 mm) to the PHONES jack on the front panel.
Sound from the speakers will be off while you are using the
headphones.
If you selected any other listening mode than Pure Audio
(European model), Stereo, Mono and Direct, connecting
headphones will switch the listening mode to Stereo.
PC
NAS