Braun 3 Serie Manual De Instrucciones página 8

Ocultar thumbs Ver también para 3 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Description
1 Foil & Cutter cassette
2 Long hair trimmer
3 Precision setting switch («lock»)
4 On/off switch
5 Charging lights (green)
6 Low-charge light (red)
7 Cleaning light (yellow)
8 Replacement light for shaving parts
9 Shaver power socket
10 Special cord set
11 Travel pouch
Charging
The best environmental temperature for
charging is between 60 °F to 95 °F / 15 °C to
35 °C. Do not expose the shaver to
temperatures higher than 122 °F / 50 °C for
extended periods of time.
Using the special cord set (10), connect the
shaver to an electrical outlet with the motor
switched off.
When charging for the first time, leave the
shaver to charge continuously for 4 hours.
Subsequent charges will take about 1 hour.
A full charge provides up to 45 minutes of
cordless shaving time depending on your
beard growth.
Shave without the cord. With normal use
the shaver will be charged automatically
after every cleaning in the Clean&Renew™
(see «C Clean&Renew™»).
Maximum battery capacity will only be
reached after several charging/discharging
cycles.
5-minute quick charge (with the special
cord set (10)) is sufficient for a shave.
If the rechargeable batteries are discharged,
you may also shave by connecting the
shaver to an electrical outlet via the special
cord set.
Charging lights
The green charging lights (5) show the charge
status of the batteries. The green charging
light blinks when the shaver is being charged
or switched on. When the battery is fully
charged, all green charging lights shine
8
permanently, provided the shaver is switched
on or connected to an electrical outlet.
Low-charge light
The red low-charge light flashes when the
battery is running low.
You should be able to finish your shave.
A Shaving
Press the on/off switch (4) to operate the
shaver (picture).
The flexible shaving foils automatically adjust
to every contour of your face (picture).
Long hair trimmer
To trim sideburns, moustache or beard, slide
the long hair trimmer (2) upwards.
Precision setting switch («lock»)
For precise handling in hard to shave areas
(e.g. under the nose) slide the switch (3) to
the right to position «lock». The centre trim-
mer and one foil will be lowered.
Tips for the perfect shave
For best results, Braun recommends you
follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right
angles (90°) to your skin.
3. Stretch your skin and shave against the
direction of your beard growth.
B Keeping your shaver in top
shape
Cleaning indicator
Your shaver should be cleaned daily in the
Clean&Renew™, and certainly when the
yellow cleaning light (7) shines constantly
after shaving. If this is not done, the yellow
light will go out after some time. The shaver's
electronics will then assume it has been
cleaned manually and a new calculation of
the time when the next cleaning is required
will be started. During the cleaning process in
the Clean&Renew™ the yellow light will flash

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

390cc370cc57725774

Tabla de contenido