Makita XCV10 Manual De Instrucciones página 8

Carrying hook
Always grab the carrying hook when handling the vac-
uum cleaner body.
► 1. Carrying hook
Stand-by switch
The stand-by switch is the switch to turn on/off the
wireless activation function. The vacuum cleaner is in
the stand-by state regardless of the switch position and
it runs when button is pushed.
► 1. Stand-by switch
Switch position
AUTO I The vacuum cleaner is in the stand-by
(ON) state and the wireless activation function
is available.
O The vacuum cleaner is in the stand-by
(OFF) state however the wireless activation
function is not available.
1
1
Status
8 ENGLISH
Switch action
To start vacuuming, press
cleaner will start in the same suction power when you
turned it off previously. When you press
while the vacuum cleaner is running, the suction power
switches between normal (1) and higher (2) suction
power. To turn off the vacuum cleaner, press
NOTE: If you want to run the vacuum cleaner along
with the switch operation of the tool connected to the
vacuum cleaner (wireless activation function), set the
stand-by switch to " I (ON)".
NOTE: To use the wireless activation function, finish
the tool registration beforehand. Refer to "WIRELESS
ACTIVATION FUNCTION" section for detail.
NOTE: When using the wireless activation func-
tion, you will not be able to stop the vacuuming
by button.
Hose band
Hose band can be used for holding the hose or free
nozzle.
To secure the hose to the vacuum cleaner body, pass
the hose band through the slot on the body. You can
attach the hose band on either side.
► 1. Hose band 2. Slot 3. Hose
button once. The vacuum
button
button.
1
2
3