Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
Step 4 – The quality of a glass of beer
an excellent draft beer has the following characteristics:
n
Note: to prevent excessive foam from forming, always use a pre-chilled
BeerTender Keg and a clean glass rinsed in cold water.
CLEaNING
In addition to routine cleaning, the BeerTender should be cleaned after daily
n
use and when you install a new BeerTender Keg.
WArNING!
and/or conventional oven.
CLEaNING afTER DaILy UsE
The drip tray and grate should be cleaned after every use. Remove the grate
n
before emptying out the drip tray. The grate must be set back in place during
normal use of the BeerTender - fig. 23.
Note: you can wash the drip tray with warm water and a mild detergent. The
drip tray is also dishwasher safe.
WArNING!
solvents or petrol.
CLEaNING afTER INsTaLLaTIoN
of a NEW BEERTENDER KEG
When you install a new BeerTender Keg you must clean the dispensing
n
spout. The spout is the only part of the appliance that comes into contact
with the beer - fig. 24.
It is essential to wash the spout either normally by hand or in a dishwasher.
Note: the dispensing spout comprises plastic and metal parts that are
permanently joined together and do not pose any problems of hygiene. Do not
attempt to separate these parts.
The beer dispensing mechanism must be cleaned using a damp cloth and
n
a mild detergent - fig. 25.
Note: use a piece of cotton to thoroughly clean all the parts - fig. 26.
28
otice_krups_beertender.indd 28
1. a head of about 3 cms;
2. a head evenly distributed around the wall of the glass that adheres to
the surface of the beer;
3. a crystal clear colour, with bubbles of carbon dioxide escaping from the
sides and bottom of the glass;
4. a temperature of 4°C to 6°C (in the glass).
Do not dry the appliance and/or its components in a microwave
Never use aggressive cleaning agents such as vinegar, acids,
10/08/10 14:29:54
Publicidad
Capítulos
Tabla de contenido
