Bose ControlSpace EP22-D Guia De Instalacion página 13

EP22-D Installation Guide
pro.Bose.com
Connection to the Dante network is provided by a single Ethernet RJ-45
connector on the back of the unit.
Note: The ControlSpace EP22-D has a label on one of the mounting
®
flanges that lists the last 6 digits of the MAC address. Important for
initial device identification, these digits are part of the device's default
network name when detected by Bose ControlSpace Designer
®
™
software. The full MAC address is also given on the back of the unit.
The EP22-D is PoE powered over the network cable from a suitable
PoE source (IEEE 802.3af) or a 12V DC power supply may be ordered
separately.
ControlSpace Designer software is used to configure the audio routing of
this device and configure and control its specific features.
The EP22-D's small form factor and integrated mounting bracket allows
for inconspicuous placement near sources or destinations, thus reducing
the amount of analog cabling required.
What's in the Box
The package contains one EP22-D device. An optional 12 V DC power
supply may be ordered separately.
Mounting
On flat mounting surface, mark screw locations through holes in the
mounting flange. Secured the unit to the mounting surface using
appropriately rated no. 6 screws through each mounting flange.
13