Braun 3 Serie Manual De Instrucciones página 7

Caution
• For safety reasons this appliance can only be operated cordlessly.
• For hygienic reasons, do not share your shaving system with other
persons.
• Periodically check the cord for damage. In case of a damaged cord, take
the charger to a Braun Service Center for replacement. A damaged or
non-functioning unit should no longer be used.
• Before plugging the charger into an electrical outlet, check whether the
voltage printed on the charger corresponds to your local mains voltage
supply.
Description
1 Foil & Cutter cassette
2 Long hair trimmer
3 Precision setting switch (« ») (380s only)
4 On/off switch
5 Charging lights (green)
6 Low-charge light (red)
7 Replacement light for shaving parts
8 Shaver power socket
9 Special cord set
10 Charging stand
11 Case (380s only)
12 Protective cap (340s only)
Charging
The best environmental temperature for charging is between 60 °F to 95 °F /
15 °C to 35 °C. Do not expose the shaver to temperatures higher than
122 °F / 50 °C for extended periods of time.
• Using the special cord set (9), connect the shaver or the charging stand (10)
to an electrical outlet with the motor switched off.
• When charging for the first time, leave the shaver to charge continuously
for 4 hours.
• Once the shaver is completely charged, discharge the shaver through
normal use. Then recharge to full capacity. Subsequent charges will take
about 1 hour.
• A full charge provides up to 45 minutes of cordless shaving time depend-
ing on your beard growth. However, the maximum battery capacity will
only be reached after several charging/discharging cycles.
• 5-minute quick charge is sufficient for a shave.
8