Shell Tuck Stitching; Elastic Stitching - Brother 885-X01 Manual De Instrucciones

BUILT-IN STITCHES — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Slide the part that you wish to sew onto
7
the arm, make sure that the fabric feeds
correctly, and then start sewing.
1
1 Arm
After selecting a stitch, slowly turn the
8
handwheel toward you
(counterclockwise) until the needle has
moved from the right side to the left.
Position the fabric under the presser foot,
9
and then adjust the fabric position until
the needle slightly catches the fold of the
hem when the needle comes to the left
end of the stitch.
1
2 3
1
2
3
Lower the presser foot lever.
0
Sew at a slow speed holding the fabric
a
with your hands, so that the needle
slightly catches the fold of the hem.
Remove the basting stitching and turn the
b
fabric right side up.
1
1 Wrong side of fabric
25
1 Wrong side of fabric
2 Fold of hem
3 Needle drop point
1 Needle
2 Needle drop point
3 Fold of hem
2
2 Right side of fabric

Shell tuck stitching

Stitch Name Pattern
12
Shell Tuck
Stitch
The Shell Tuck Stitch can be used to sew a picot (lace-
like) edge on lightweight fabric.
Adjust the thread tension so that it is
1
tighter than normal.
Place the fabric under the presser foot so
2
that it will be sewn along the bias, with
the straight stitches sewn on the seamline
and the zigzag stitches sewn slightly over
the folded edge.
Sew at a slow speed.
3
1 Straight stitches
2 Zigzag stitches

Elastic stitching

Stitch Name Pattern
13
Elastic Stitch
You can use the Elastic Stitch for mending, sewing
elastic or joining fabric. Each is explained below.
■ Mending
Place the reinforcement fabric under the
1
area you want to mend.
• Use the basting pins to hold the
reinforcement fabric.
Stitch
Stitch Width
Length
[mm (inch)]
[mm (inch)]
2 (1/16) 5 (3/16)
2
1
Stitch
Stitch Width
Length
[mm (inch)]
[mm (inch)]
1 (1/16) 5 (3/16)