Uncoupling The Pto Shaft; Transport; Zi-Hs16E - Zipper Maschinen ZI-HS16E Manual De Instrucciones

14.2.2 Uncoupling the PTO shaft

There is a motor contact device inside the self-locking sleeve. When the sleeve is
removed, the motor cannot start. So the machine only works when it is connected to
motor only or to PTO only.
To uncouple the PTO shaft proceed as follows:
1. Reduce tractor throttle to IDLE before disengaging PTO. Apply the parking brake and turn
off the engine.
2. Pull up the locking pins and slide the lower draft arms of the tractor off from the splitter
hookup pins.
3. Pull up the hitch pin and slide the upper draft arm off from the mounting bracket.
4. Release the spring pins located on both ends of the driveshaft. Slide the PTO driveshaft off
from the PTO shaft ends on the gearbox and tractor respectively.
5. Mount the plastic self-locking sleeve.
15

TRANSPORT

15.1

ZI-HS16E

For easier transport, the log splitter has two wheels, a support wheel and a transport handle.
ZIPPER MASCHINEN GmbH
ZI-HS16E / ZI-HS22EZ / ZI-HS30Z / ZI-HS30EZ
www.Zipper-Maschinen.at
N O T I C E
N O T I C E
 When using a crane for lifting, attach the crane
hook only to the intended lifting point (a) - see
illustration on the left.
 Never attach the crane hook to the transport
handle (b)!
 Before moving the log splitter, make sure that the
cover on the oil tank is firmly closed!
 To move the splitter, grasp the handle (b) and
carefully tilt machine backwards!
A. Moving support
position: To mount the support wheel, remove the
spring bolt and push the square tube with the
support wheel into the holder (1). Then select the
appropriate hole and fix the square tube in the
desired position using the spring bolt (2).
TRANSPORT
wheel to the transport
39