Setting The Sleep Timer - Sanyo AVM-1341S Manual Del Propietário

CONNECTING A VCR OR OTHER EXTERNAL EQUIPMENT
Switch off TV and external equipment before connecting cables.
1. Connect VCR Audio Out (R/L) and Video Out
Video Input .
For Mono VCR (Single Audio Jack) only connect VCR Audio (L) Out to TV
Audio (L) Input.
2. Press POWER to turn on the TV. See
3. Press the GAME/VIDEO MODE key
from the equipment you have connected to the A/V jacks. See page 6 for remote control
.
operation
Note: The TV will reproduce stereo sound only from stereo signals received through the
Audio jacks.
REMOTE CONTROL
GAME
POWER
MODE RESET
VIDEO
MODE
1 2 3
5 6
4
9
7 8
CAMCORDER

SETTING THE SLEEP TIMER

The Sleep Timer will switch off the TV automatically.
1. Press the SLEEP key.
2. Use the 0 key to select the desired time
(from 30 minutes up to 3 hours).
Note: The Sleep Timer cancels when the
TV is turned off or if a power
failure occurs.
to the TV Audio Input (R/L) and
.
Turn on external equipment also.
to select program source: TV signal or signal
TV A/V INPUT JACKS
POWER POWER VIDEO IN VIDEO IN L-AUDIO-R L-AUDIO-R
BACK VIEW OF VCR
A/V JACKS
IN
RF
R- AUDIO -L
CHANNEL
CH3 CH4
OUT
R- AUDIO -L
GAME
POWER
RESET
MODE
VIDEO
MODE
1 2 3
4 5 6
7 8 9
CAPTION SLEEP
0
MENU RECALL
VOL VOL
CH
MUTE DISPLAY
QuickTips
Make sure all cable
connectors are fully
seated on jacks.
Always match cables
according to the
colors;
RED
audio,
WHITE
audio and
YELLOW
video.
A solid Blue screen
with the word Game
displayed means that
the Game/Video mode
is selected, but no
VIDEO
signal is being
detected at the Video
VIDEO
jack. Check connec-
tion. Turn on external
equipment.
Sleep : Clear
Sleep : 3:00
Sleep : 2:30
Sleep : 2:00
Sleep : 1:30
Sleep : 1:00
Sleep : 0:30
Use 0 key
for right
for left
for
9