Gaggenau CM 450 Instrucciones De Instalación página 10

7 Securely insert the front line into the appliance
(snaps into place). For this purpose, put the
appliance to be plugged in just on to the edge of
the unit. Plug the power cord into the socket.
Plug transformer into dedicated receptacle in an
accessible cabinet adjacent to the coffee maker
(depends on the built-in situation). Do not plug into
a receptacle behind the appliance.
8 Push the appliance into the unit until it clicks into
place. Check that the appliance is in the middle. If
necessary, align the appliance. To do so, pull the
appliance out a little, remove the appropriate
spacers (d) and attach to the left side (top and
bottom). Push the appliance into the unit until it
clicks into place.
9 Take hold of the appliance door on the right next to
the outlet and open. Remove the drip tray
the cover on the bottom left-hand side forwards
(X)
and remove. Pull out the accessories drawer
and put to one side.
10 First, screw on the appliance as shown using 2 of
each of the fastening screws
2 sleeves . Then screw tight at the top right of the
(i)
cabinet using 1 fastening screw
11
Only for the expert:
In very few cases, the door of the fitted fully
automatic coffee machine can jam due to a warpage
in the cabinet where the unit is built in. The door
can be adjusted. To do this adjust the hinges at the
top and the bottom:
‒ Adjust the depth of the door by turning the
screws (V) .
‒ Remove the hinge dampers at the top and
bottom of the hinges. Turn the screws
adjust the inclination and the horizontal position
of the doors.
‒ Re-fit the hinge dampers.
12 Insert the cover
(X)
fastening screws
(g)
13 Replace the drip tray
and close the appliance door.
(Z)
10
(Y)
and as well as
(e) (f)
(e) and sleeve
(W)
and fix with the two black
.
and accessories drawer
(Y)
Removal
1 Undo all screws.
2 Slightly pull out the appliance.
3 Remove the power cord from the socket.
4 Disconnect the appliance from the transformer.
5 Fully remove the appliance.
. Pull
(Z)
(h) .
to