Connecting Disposer To Mounting Assembly - Westinghouse Platinum Serie Manual Del Usuario

Installation (continued)
CONNECTING THE DISPOSER TO THE MOUNTING ASSEMBLY
- Adjust the disposer position to make the elbow line up with the trap (see Fig . 11) .
- The disposer must be installed so that the reset button is readily accessible
(see Fig . 12) .
- Line up the disposer under mounting assembly making sure that the cushion
mount is in place. Guide the step of the top supporting ring to fit in the bottom
supporting ring . Turn the bottom supporting ring counter-clockwise completely
(see Fig .13 and Fig .13a) .
If when you turn the bottom supporting ring it hits a limit before it tightens, then:
1 . Release and lower the waste disposer .
Top
supporting
ring
Cushion Mount
Bottom
supporting
ring
8
Fig. 11
Elbow
Trap
Disposer body
Reset Button
Fig. 12
Sink
Step
Fig.13 Fig.13a
Sink