Setting Up And Using Your Airline System - Samson AirLine AF1 Manual Del Propietário

Setting Up and Using Your AirLine System

Samson AirLine
The basic procedure for setting up and using your AirLine System takes only a few minutes:
1. For your AirLine system to work correctly, both the receiver and transmitter must be set to the same channel. Remove all packing
materials (save them in case of need for future service) and check to make sure that the supplied AP1 receiver and AF1 or AG1
transmitter are set to the same channel (a complete channel plan is printed on page 71 in this manual). If these channels do not
match, contact your distributor or, if purchased in the United States, Samson Technical Support at 1-800-372-6766.
2. Physically place the AP1 receiver on the ground in front of you. It works best in this position. The general rule of thumb is to main-
tain "line of sight" between the receiver and transmitter so that the person using the transmitter can see the receiver.
3. Extend the AP1 antennas and spread the tips horizontally outwards approximately 5 inches.
4. Make sure the Power On-Off switch in your AF1 or AG1 transmitter is set to "Off" and that the 15 dB pad is also Off (switch away
from the direction of the arrow). Pull back gently on the AF1 or AG1 battery cover at the ribbing and pry it upwards to remove it.
Please use care when opening this cover as undue force can damage it. Install a fresh AAA alkaline battery in the battery
compartment, being sure to observe the polarity markings. Then carefully replace the battery cover and gently press down on it
until it clicks. Momentarily turn on the power to the transmitter by sliding its Power on-off switch in the direction of the arrow; the
"Power/Battery" LED will flash if the battery is sufficiently strong (if it lights steadily, the battery has less than 2 hours of power
remaining and should be replaced). Once battery strength is verified, turn the transmitter off again and plug it into your electric guitar
or bass.
5. With the Power switch on the AP1 set to the "Off" position (away from the arrow), gently press down on the AP1 battery
compartment latch and swing the battery compartment door open (do not use force when opening or closing the battery door; it is
hinged and not meant to be removed). Install a fresh 9-volt battery, then carefully close the battery door. Alternatively, you can
connect a 12-volt AC adapter (available as an option from your Samson dealer). Turn the AP1 on momentarily to confirm that the
15