Guided Tour - AP1 Receiver
5: Antennas - Swivel mounting allows full rotation for optimum positioning of the
dual AP1 antennas. In normal operation, extend both antennas vertically and
spread the tips horizontally outwards approximately 5 inches. For convenience,
they can be folded inward when transporting the AP1. See the "Setting Up and
Using Your AirLine System" section on page 15 in this manual for more information
about antenna positioning.
6: Battery compartment latch - Press gently on this latch to open the AP1 battery
compartment (see #7 below).
7: Battery compartment - Insert a standard 9-volt alkaline battery here, being sure
to observe the plus and minus polarity markings shown. We recommend the
Duracell MN 1604 type battery. Although rechargeable Ni-Cad batteries can be
used, they do not supply adequate current for more than four hours.
WARNING: Do not insert the battery backwards; doing so can cause severe dam-
age to the AP1 and will void your warranty. Note that the AP1 can also be AC
powered with the use of an optional 12 volt adapter available from your Samson
dealer (see #10 on the following page).
8: Plastic screwdriver - Specially designed for use in adjusting the AP1 Squelch
control (see #11 on the following page). See the "Setting Up and Using Your
AirLine System" section on page 15 in this manual for more information.
5
Samson AirLine
ON
TX
POWER
BATT. LOW
PEAK
∞
LEVEL
AP1
UH F R E CE I V E R
7
8
SAMSON