Samson AirLine AF1 Manual Del Propietário página 19

Setting Up and Using Your AirLine System
Samson AirLine
11. Temporarily turn down the level of your amplifier or mixer and turn off the power to your transmitter, leaving the AP1 receiver on.
Then restore the previously set level of your amplifier or mixer. With the transmitter off, the receiver output should be totally silent; if
it is, skip ahead to the next step. If it isn't (that is, if you hear some noise), you may need to adjust the AP1 Squelch control. When the
Squelch control is at its minimum setting, the AirLine system always provides maximum range without dropout; however, depending
upon the particular environment your system is used in, you may need to reduce that range somewhat in order to eliminate band noise
when the AF1 or AG1 transmitter is turned off. To do so, use the provided screwdriver to rotate the Squelch control completely
counterclockwise (to the "Min" position), then slowly turn it clockwise until the noise disappears. If no noise is present at any posi-
tion, leave it at its fully counterclockwise "Min" position (so as to have the greatest overall range available).
12. When first setting up your AirLine System in a new environment, it's always a good idea to do a walkaround in order to make sure
that coverage is provided for your entire performance area. Accordingly, turn down the level of your audio system and turn on both
the transmitter and receiver. Then restore the level of your audio system and while playing your electric guitar or bass at a normal
performance level, walk through the entire area that will need to be covered. As you do so, observe the "TX/Peak" LED on the AP1
receiver to make sure that it is steadily lit green, indicating that it is receiving sufficiently strong RF signal. Always try to minimize the
distance between transmitter and receiver as much as possible so that the strongest possible signal is received from all planned trans-
mission points. In certain environments, it may be desirable to angle the AP1's antennas differently from the vertical position.
If you have followed all the steps above and are experiencing difficulties, contact your local distributor or, if purchased in the
United States, call Samson Technical Support (1-800-372-6766) between 9 AM and 5 PM EST.
17