Controllable Functions - Trix 18.3 Serie Manual De Instrucciones

Function
• Built-in electronic circuit for operation with a conventional
DC power pack (max. ±12 volts), Trix Systems, Trix Selectrix or
NMRA DCC digital systems.
• Automatic system recognition between digital and analog
operation.
• SoftdriveSinus propulsion with a maintenance-free motor.
• No automatic system recognition between Selectrix (SX) and
DCC.
• The full range of functions is only available under Trix Sys-
tems and under DCC.
• Headlights for the locomotive change over with the direction
of travel. They can be turned on and off in digital operation.
• This locomotive can be retrofitted with a smoke generator.

Controllable Functions

Headlights
1)
Smoke generator
1) Not included in delivery scope.
12
Notes on digital operation:
• The first time the locomotive is used in a digital system (Selectrix
or DCC), the decoder must be set for this digital system. To do
this, the decoder must be programmed once in this digital system
(Example: changing an address).
• The operating instructions for your central unit will give you
exact procedures for setting the different parameters.
• The values set at the factory were selected to guarantee the
best possible running characteristics.
• This locomotive comes from the factory programmed for the
digital address "01" (Selectrix) / "03" (DCC) Number of speed
levels that have been set: 28 (DCC) and 31 (Selectrix).
• Correct programming with the 66920 Mobile Station is pos-
sible starting with version number 034.
• Information about DCC Operation:
The setting done at the factory does not permit operation with
opposite polarity DC power in the braking block. If you want
this characteristic, you must do without conventional DC
power operation (CV29 / Bit 2 = 0).
Analog DC Selectrix
Continuously on Headlight button
Continuously on
Headlight button
function
DCC
Button 1