Koenic KIP 1331 Manual De Instrucciones página 24

English
Timer
Note: Using the timer function the
induction cooking hob will automatically
turn to standby after a preset time
elapsed. The min./max. adjustable times are
0:01 minute/3:00 hours.
Set the timer
Fig.
10
To activate the timer press the timer
1
during cooking. The display shows
00:00 flashing.
The residual time can be set using
2
the +/– buttons. With a single tap of
the +/– button the value changes
by 1 minute. Keep the +/– button
pressed, the value changes quickly with
10 minutes increments.
Press timer button again to confirm
3
the set value.
Note: If the timer is activated the display
alternatingly shows the residual time and the
preset temperature or power level.
After preset time elapsed the induction
cooking hob will be switched to standby and
the display shows blinking H.
Note: The residual time can be changed
when the timer is activated. Press the
timer button and change the time with
+/– buttons. Press the timer button again to
confirm.
24
IM_KIP1331_170308_V05_HR.indb 24
Key Lock
The cooktop can be locked against
unintentional use (e.g. as child protection). If
the lock is activated all control buttons except
the on/off switch are locked.
Press + and – buttons at once to lock
Fig.
11
the control panel. Press + and – buttons
at once for approx. 1 second to unlock
the control panel.
Residual heat indicator
The induction cooking plate has a
Fig.
12
residual heat indicator. If the cooking
plate is off but still hot, H is shown in
each power level display. The display
shows L when the cooking plate cooled
down to a safe temperature.
Cleaning and care
Warning
When cleaning, never use solvents or
abrasive materials, hard brushes, metallic or
sharp objects. Solvents are harmful to human
health and can attack plastic parts, while
abrasive cleaning mechanisms and tools may
scratch the surface(s).
Unplug the induction cooker and let it
Fig.
13
cool down completely before cleaning.
Clean the product's exterior surfaces
Fig.
14
with a slightly damp cloth and then dry
them thoroughly. Make sure that no
water enters the product interior (for
example, through the switch).
8/3/17 1:38 PM