Switch Positions - SEVERIN HAIR CARE LS 0670 Manual Del Usuario

knowledge, unless they have been given
supervision or instruction concerning the
use of the appliance by a person
responsible for their safety.
■
Children should be supervised to ensure
that they do not play with the appliance.
■
Caution: Keep any packaging materials
well away from children, as they are a
potential source of danger e.g. from
suffocation.
■
No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
■
This appliance is intended for domestic use
only and not for commercial applications.
■
In order to comply with safety regulations
and to avoid hazards, repairs of electrical
appliances must be carried out by qualified
personnel, including the replacement of the
power cord. If repairs are needed, please
send the appliance to one of our customer
service departments. The address can be
found in the appendix to this manual.

Switch positions

The appliance is equipped with a 3-position
switch allowing for the following settings:
Functions:
0 = Off
1 = Half power
2 = Full power
Operation
Make sure the appliance is used on dry hair
only.
- Insert the plug into a wall socket.
- Turn the curler on. The indicator light
comes on.
- Let the curler heat up for approximately 5
minutes.
- Divide the hair into separate strands, grip
the end of a strand with the clamp and curl
it up to the hairline.
The integrated swivel makes it easy to use
the curler in this way.
- Hold the hair curled up for a few seconds,
then open the clamp, hold the curl and
remove the curler gently from the hair by
turning it.
■
Make sure the hot parts of the curler are
kept away from the scalp.
- Let the hair cool down sufficiently before
brushing it out.
- Switch the appliance off after use. When
the indicator light goes out, remove the plug
from the wall socket.
Round brush attachment
To use the round brush, it must be fitted over
the clamp in such a way that the locking catch
is securely engaged in the corresponding
socket. To remove the brush, push the locking
catch forward out of its socket until it locks into
place on the axis of the mounting clip. The
brush can now be pulled off from the clamp.
- The round brush is designed for shaping
the hair. To achieve this, the hair should be
divided into single strands (not too thick)
and then spread evenly over the brush,
turning them inwards or outwards as
desired.
- Apply for a few seconds at a time only,
while allowing the hot air to take effect on
the hair. Let the strands uncurl afterwards.
- Let the hair cool down sufficiently before
brushing it out.
General cleaning and care
■
Before cleaning the appliance, ensure it is
disconnected from the power supply and
has cooled down completely.
■
To avoid the risk of electric shock, do not
clean the appliance with water and do not
immerse it in water.
■
Do not use abrasives or harsh cleaning
solutions.
- If necessary, the housing may be wiped
with a dry lint-free cloth.
- Remove any loose hair from the
attachments after use.
10