Blaupunkt TSA 1300 Instrucciones De Montaje página 10

TSA 1300
Positive/negative connection
The cross section of the positive and
negative cables must be at least 6 mm
Use cable grommets to protect cables
against sharp-edged holes. Securely
screw a standard 6 mm
to an interference-free earth connection
point (bolt connected to the car body, car
body sheet metal) – though do not con-
nect it to the negative terminal of the bat-
tery. Scratch the surface down to the bare
metal at the point at which the earth con-
tact is made and apply graphite grease.
Connection examples
Before you can connect the cables to the
amplifier, you must first detach the top half
of the housing shell (see "Removing the out-
er housing").
Connecting the voltage supply ......... Fig. 4
Connection to car radios with
RCA output ...................................... Fig. 5
Connection to car radios with
loudspeaker output .......................... Fig. 6
Loudspeaker connections ........ Fig. 7, 8, 9
Connecting the wire remote
control (REMOTE BASS) ............... Fig. 10
+12V
The switching line must be connected when
connection is carried out using the RCA jacks
or the loudspeaker jacks of the car radio.
10
2
.
2 negative cable
GAIN control
You can use the GAIN control to adjust the
input sensitivity of the Blaupunkt power am-
plifier to the output voltage of your car ra-
dio's preamp output.
The setting can be adjusted between 0.3 V
and 8 V.
When connecting a car radio produced by
another manufacturer, you must adjust the
input sensitivity in accordance with the in-
formation provided by the manufacturer.
Please note that the GAIN control is not a
control for adjusting the volume!
REMOTE BASS
Connection for the supplied wire remote con-
trol (5 m).
This gives you the convenience of control-
ling the bass level remotely (see Fig. 10).
If you want to use the remote control, the
device must be operated with the low-
pass filter activated (X-OVER switch set
to position LP).
INPUT
Preamp inputs for the right and left chan-
nels. Please use high-quality Blaupunkt RCA
cables for this connection.
OUTPUT
Outputs for connecting an additional ampli-
fier (formation of chains of amplifiers). Please
also use high-quality Blaupunkt RCA cables
for this connection.