Blaupunkt TSA 1300 Instrucciones De Montaje página 9

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
In confined installation locations, the ampli-
fier can also be installed without the outer
housing. To do so, you must attach the in-
cluded mounting tabs to the amplifier hous-
ing. (See Fig. 2).
When choosing an installation location, you
must select one which is dry and which pro-
vides sufficient air circulation to cool the
amplifier.
Use cable grommets to protect cables
against sharp-edged holes.
Use loudspeakers with an impedance of
2-4
. Observe the maximum load rating
(music power rating).
Use loudspeaker connecting cables up to
2
4 mm
. Do not connect loudspeakers to earth
– only use the correct terminals as indicat-
ed.
The cross section of the positive and
negative cables must be at least 6 mm
The positive cable between the battery
and the amplifier must be protected di-
rectly at the battery using a fuse holder
(80 amperes).
Removing the outer housing
(see Fig. 3)
1. Undo the cover's screw (A) that is locat-
ed above the switches and controls. Af-
terwards, lift the cover and carefully re-
move it.
2. Undo the four screws (B) that secure the
top half of the housing shell and then re-
move the top half of the housing.
3. Undo the six screws (C) that secure the
underside of the housing and then take
the amplifier out of the bottom half of the
housing shell.
Class D Monoblock Booster TSA 1300
The amplifier is suitable for connection to car
radios that are equipped with RCA connec-
tions.
If you want to connect it to car radios that
are equipped with an ISO connection, please
use the Blaupunkt ISO-RCA adapter.
Usage options and loudspeaker connec-
tion:
Channels
Max. power
4 ohms
Max. Power
2 ohms
RMS power
4 ohms
2
.
RMS power
2 ohms
Frequency
response
Signal-to-noise
ratio
Input sensitivity
Stability
Low pass filter
(Low Pass)
Subsonic filter
Remote control
for bass level
Dimensions
WxHxD (mm)
Inner housing
Outer housing
TSA 1300
TSA 1300
1
1 x 600 watts
1 x 1000 watts
1 x 300 watts
1 x 500 watts
20 - 300 Hz
> 95 dB/A
0.3 - 8 V
2 ohms
40 - 300 Hz
20 - 55 Hz
Yes
205 x 45 x 177
253 x 67.5 x 210
Fig. 9
Fig. 9
Fig. 9
Fig. 9
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

7 607 792 060

Tabla de contenido