Trying Out The Instrument; Selecting The Channels; Setting The Output Voltage And Current Limit - Rohde & Schwarz NGE100 Manual Del Usuario

®
R&S NGE100
5

Trying Out the Instrument

This chapter describes some basic functions that you can perform with the R&S
NGE100.
5.1

Selecting the Channels

To select a channel, press the corresponding channel key. The key illuminates.
5.2

Setting the Output Voltage and Current Limit

To set the output voltage and current limit via Live-Mode:
1. Long press the rotary knob to enter into the setting mode. The font color of
channel 1 voltage setting changes to blue.
2. Move to the desired parameter via the arrow keys.
3. On the desired parameter, rotate the knob to adjust its value.
Alternatively:
1. Press Voltage or Current key on the front panel.
2. Press the desired channel key to activate the respective voltage or current
limit setting for that channel. The value on the respective channel becomes
editable (in blue) and the digit for adjustment is indicated by a cursor.
3. Press the right or left arrow key to move the cursor.
4. Press the up / down arrow key or turn the rotary knob to change the value of
the digit indicated by the cursor. The new value registers immediately.
Getting Started 5601.1308.02 ─ 04
Setting the Output Voltage and Current Limit
Trying Out the Instrument
20