Switching On The Instrument - Rohde & Schwarz NGE100 Manual Del Usuario

®
R&S NGE100
The power cable must be plugged in before signal circuits can be connected.
Never use the product if the power cable is damaged. See
ing On the Instrument",
Voltage selector
The voltage selector selects the mains voltage between 115 V and 230 V.
Ethernet connector
This connector is used for establishing remote control via SCPI or LXI. See sec-
tion "Ethernet Setup" in the user manual for more information on the connection
setup.
The Ethernet option NGE-K101 must be installed for this function to be available
in the instrument.
USB connector
The USB connector is a Type-B connector for remote control operation.
Digital I/O connector
The Digital I/O connector is a terminal block for external trigger input or output.
The Digital Trigger I/O option (NGE-K103) must be installed for this function to be
available in the instrument.
4.2

Switching On the Instrument

Prior to switching on the instrument, check if the value on the voltage selector
corresponds to the mains voltage (115 V or 230 V). Switch it, if necessary, and
change the power fuse of the instrument accordingly.
To change the power fuse:
1. Peel off the yellow label sticker on the AC inlet.
2. Pull out the fuse holder which is located directly on top of the socket.
3. Remove the preloaded fuses from the fuse holder.
Getting Started 5601.1308.02 ─ 04
on page 18 for more information.
Instrument Tour
Switching On the Instrument
Chapter 4.2, "Switch-
18