Assemble The Face Shield; Installing The Handle; Installing The Wheels; Installing The Welding Gun - Craftsman 196.205080 Manual De Usuario

ASSEMBLE THE FACE SHIELD

1. Remove the lens retaining pegs and
shield handle nut from the arm of the
shield handle. (DO NOT DISCARD!)
2. Place the shaded lens into the space
provided on the inside of the face shield.
3. Screw the lens retaining nuts into the
holes to either side of the lens until they
are tight against lens.
4. Insert threaded peg on shield handle into
hole on face shield. Press firmly until
threaded peg and smaller peg below it
are locked into place.
5. From inside of shield, screw the shield
handle nut tightly onto peg threads.
Figure 2. Face Shield Assembly

INSTALLING THE HANDLE

1. Install the two handle mounts, using the
M6 x 20 screws provided.
2. Insert the tabs of the welder handle into the
slots provided on the top of the welder.
3. Insert a large flat head screw (included in
the accessories bag) into each hole on
the top of the welder handle.
4. With a flat tip screwdriver, securely
tighten both screws. (see Figure 3)
Figure 3. Handle Installation

INSTALLING THE WHEELS

1. Gently lay the welder on its side and
install the two front castor wheels (D) into
the threaded holes in the front of unit.
2. Return the unit to upright position and
block up the rear of the welder at least 6
inches from the ground.
3. Slide the Wheel Axle (B) through the
square tube at the rear of unit.
4. Install the Rear Wheels (A) and Wheel
Retaining Rings (C) as shown in Fig. 4.
Figure 4. Wheel Installation

INSTALLING THE WELDING GUN

1) Remove the protective cap covering the
gun port on the front of the unit.
2) Insert the gun connector into the port and
hand tighten the threaded end.
Figure 5. Welding Gun Installation
11 11