DeWalt DWE46172 Manual De Instrucciones página 8

English
nOTE: The amount of dust retained by the dust extractor
vacuum is dependent on its filter system. Refer to the dust
extractor vacuum instruction manual for more information.
All D WALT dust collection shrouds are designed to connect
e
and secure easily with the D
e
connector. The DWV9000 connector comes pre-installed on
some D WALT dust extractors. Consult your local dealer for
e
compatible extractors.
Connecting the DWV9000 Onto the
Shroud (Fig. E)
nOTE: If the DWV9000 is not installed on your dust
extractor hose refer to Installing the DWV9000 on a Dust
Extraction Hose.
1. With the DWV9000 connector
onto the shroud's dust port
2. Lock the DWV9000 connector to secure.
Fig. E
6
Installing the DWV9000 on a Dust
Extraction Hose (Fig. F, G)
The DWV9000 is can be attached to a 1–1/4" or 2–1/2"
(31.8 mm or 63.5 mm) dust extraction hose. The DWV9000
can be used with a 2–1/2" (31.8 mm) hose with the use of
the DWV9190 adaptor.
For 1–1/4" (31.8 mm) hoses:
1. Remove the existing hose connector
clockwise, or if connector is permanently attached,
remove by cutting.
2. Install the universal DWV9000 connector
hose by turning counterclockwise.
Fig. F
6
WALT universal DWV9000
unlocked, slide it
11
6 .
11
12 by twisting
onto the
13
12
For 2–1/2" (63.5 mm) hoses:
1. Use a DWV9190 adaptor
existing hose connector 12
2. Install the universal DWV9000 connector
adaptor by turning counterclockwise.
Fig. G
12
DWV9190
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.

WARNING: For your own safety, read the instruction
manual for both the grinding tool and the dust
extractor vacuum before using any accessory. Failure
to heed these warnings may result in personal
injury and serious damage to the tool and the
accessory. When servicing this tool, use only identical
replacement parts.
nOTE: The amount of dust retained by the dust extractor
vacuum is dependent on its filter system. Refer to the dust
extractor vacuum instruction manual for more information.
1. Ensure all assembly instructions have been completed.
2. Turn the dust extractor vacuum on as instructed in the
dust extractor vacuum instruction manual.
3. Turn the tool on as instructed in the tool instruction
manual and allow it to reach full speed before making
contact with work surface.
4. Place the surface grinding shroud to flat work surface,
such as a floor or wall, and begin grinding.
5. When surface grinding is complete, turn the tool off and
disconnect from the power source. Allow the tool to
stop rotating before laying it down.
nOTE: The surface grinding shroud and dust extractor
vacuum will only be effective when used with a diamond
surface cup wheel on a flat surface.
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.
13 , and slide it onto the
.
11 onto the
13
11