Premier MCO-4992 Manual De Instrucciones página 23

5. Wind the thread to thread guide 2 (7) from thread guide 1(6 )after passing through the thread clamp
(9), shown in Fig 5. 6
6.Threading the end of the thread through the take-up lever(4), shown in Fig 6
7.Threading the thread through the thread guiding spring1(11) after passing through the take-up lever(4,
shown in Fig7.
8. Wind the thread through the thread guiding spring 2(14) after passing through the thimble ring (13),
shown in Fig8.
9. Wind the thread end through thread guiding spring 2(14) to the pinhole of the sewing needle (16),
shown in Fig9.
10.Threading can be assisted by the threader (36), shown in Fig10. Threading the steel wire of the
threader (36) to pass through the pinhole of the sewing needle (16) and then insert the thread into the
steel wire of the threader (36). Hold the thread end by hand and pull back the threader (36), and the
thread end will pass through the pinhole of the sewing needle (16).
Attention
1. Make sure the thread pass through thread clamp (9). When the thread passes through thread clamp
(9), poke slightly the thread clamp (9) to make sure there's no thread jamming.
2. It is strictly required to follow the above steps during threading.
Installation and extraction of Bobbin thread
1. Lift presser foot and hold the upper thread by hand with a extraction length of about 10cm, shown in
Fig1.
2. Take down transparent cover (18), shown in Fig2.
3.Put the bobbin (33) into the rotating shuttle of bobbin thread, shown in Fig3.
P-6