Premier MCO-4992 Manual De Instrucciones página 28

9. Stamp foot switch (31) gently to start sewing. Bar tacking sewing for 5-6 stitches horizontally and
release foot switch to stop sewing.
10. Rotate hand wheel (24) to lift sewing needle (16) to the highest position and then adjust
adjustment wheel (2) to function 13.
11. Stamp foot switch (31) gently to start the right hole sewing and the sewing needle will move further
and further from the button hole.
12. Rotate hand wheel (24) to lift sewing needle (16) to the highest position and then adjust
adjustment wheel (2) to function 14.
13. Stamp foot switch (31) gently to start sewing. Bar tacking sewing for 5-6 stitches horizontally and
release foot switch to stop sewing.
14. Lift presser foot, take out texture and cut the thread.
Zipper sewing
It requires zipper presser foot (41) for zipper sewing.
1. Change zipper presser foot (41) (Zipper presser foot can be installed on both left and right according
to the convenience of zipper sewing.)
2. Rotate hand wheel (24) to lift sewing needle (16) to the highest position and then adjust
adjustment wheel (2) to function 1 or
3. Lift presser foot and unzip the zipper to make the zipper teeth of single side well matched with the
texture. Put them under the presser foot and make the pinpoint of sewing needle (16) 6-8mm away
Release foot switch until the end of marking line to stop sewing.
2.
the function
the function
the function
P-11