Intended Use; Optional Accessory - DeWalt D25832 Manual De Instrucciones

3. Rotate the bail/loop style auxiliary handle to the
desired position.
4. Lock the bail/loop style auxiliary handle in place by
securely tightening the screw for handle mounting
rotating it clockwise so that the assembly will not rotate.
Fig. B
11
12
Chisels and Chisel Holder

WARNING: Burn Hazard. ALWAYS wear gloves when
changing chisels. Accessible metal parts on the tool
and chisels may get extremely hot during operation.
Small chisels of broken material may damage
bare hands.
The chipping hammer can be fitted with various chisels
depending on the desired application. Use sharp
chisels only.
Inserting and Removing SDS MAX
Chisels (Fig. C)
NoTE: Accessories and attachments used must be
lubricated around the SDS MAX fitment before installation.
1. Insert chisel in the chisel holder
pressure while rotating to secure the chisel into place.
The chisel shank must be clean.
2. Ensure the chisel is properly engaged.
NoTE: The chisel needs to move several centimeters in
and out of the chisel holder
Fig. C
6
3. To remove the chisel pull back the locking sleeve
pull the chisel out.
Chisel Position Adjustment
Turn the mode selector to chisel adjustment icon (Refer to
Mode Selection) to adjust the chisel to the desired position.
There are multiple positions to set the angle of the chisel.
NoTE: After finding the desired position, slightly
maneuver the chisel back and forth to ensure the chisel is
properly engaged.
12
3
2
6 and apply downward
6 when properly engaged.
7
and
7
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Proper Hand Position (Fig. D)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the bail/
loop style auxiliary handle 2
main handle .
5
Fig. D
2

Intended Use

Your heavy-duty chipping hammer is designed for
professional concrete chiseling applications.
Do NoT use under wet conditions or in presence of
flammable liquids or gases.
Your heavy-duty chipping hammer is a professional
power tool.
Do NoT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
SHOCKS® Active Vibration Control
System
For best vibration control, hold the tool as described in
Proper Hand Position and apply just enough pressure so
the damping device on the main handle is approximately
mid stroke. The hammer only needs enough pressure to
engage the active vibration control. Applying too much
pressure will not make the tool chip faster and active
vibration control will not engage.
D WALT Tool Tag Ready (Fig. A)
e

Optional Accessory

Your hammer comes with mounting holes
fasteners for installing a D WALT Tool Tag. You will need a
e
T15 bit tip to install the tag. Only use the screws provided.
The D WALT Tool Tag is designed for tracking and locating
e
professional power tools, equipment, and machines using
the D WALT Tool Connect™ app. For proper installation
e
and use of the D WALT Tool Tag refer to the D
e
Tag manual.
ENGlIsh
with the other hand on the
5
10 and
WALT Tool
e
21