Intended Use - DeWalt SDS MAX Manual De Instrucciones

Side Handle (Fig. B)

WARNING: To reduce the risk of personal injury,
ALWAYS operate the tool with the side handle
properly installed. Failure to do so may result in
the side handle slipping during tool operation and
subsequent loss of control. Hold tool with both hands
to maximize control..
The side handle clamps to the front of the gear case and
2
may be rotated 360˚ to permit right- or left-hand use.
Mounting the Straight Side Handle
(Fig. B)
1. Widen the ring opening of the side handle
rotating it counterclockwise.
2. Slide the assembly onto the nose of the tool, placing
the steel ring 12 onto the collar
and sleeve.
3. Rotate the side handle assembly to the desired position.
For hammerdrilling horizontally with a heavy drill
bit, place the side handle assembly at an angle of
approximately 20° to the tool for optimum control.
4. Lock the side handle mounting assembly in place by
securely tightening the handle
so that the assembly will not rotate.
Fig. B
12
2
Bit and Bit Holder

WARNING: Burn Hazard. ALWAYS wear gloves when
changing bits. Accessible metal parts on the tool and
bits may get extremely hot during operation. Small
bits of broken material may damage bare hands.
The rotary hammer can be fitted with various chisel bits
depending on the desired application. Use sharp drill bits
and chisels only.
Inserting and Removing SDS MAX Bits
(Fig. C)
1. Insert bit in the bit holder
pressure while rotating to secure the bit into place. The
bit shank must be clean.
2. Ensure the bit is properly engaged.
NoTE: The bit needs to move several centimeters in and
out of the bit holder 6 when properly engaged.
by
2
3 , past the bit holder
2 rotating it clockwise
3
6 and apply downward
Fig. C
6
3. To remove the bit, pull back the locking sleeve
pull the bit out.
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Proper Hand Position (Fig. D)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the mounted
side handle 2 , with the other hand on the main handle
Fig. D
2

Intended Use

Your heavy-duty rotary hammer is designed for professional
concrete drilling and chiseling applications.
Do NoT use under wet conditions or in presence of
flammable liquids or gases.
Your heavy-duty rotary hammer is a professional power tool.
Do NoT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
SHOCKS® Active Vibration Control
System
For best vibration control, hold the tool as described in
Proper Hand Position and apply just enough pressure so
the damping device on the main handle is approximately
mid stroke. The hammer only needs enough pressure to
engage the active vibration control. Applying too much
pressure will not make the tool actuate faster and active
vibration control will not engage.
ENGlIsh
7
7 and
5 .
5
23