Husqvarna MZ48 Manual Del Operador página 17

LUBRICACIÓN
Programa de lubricación
*
Cambie el aceite del motor cada 50 horas.
12/12 Lubricar con una pistola de engrase
1/52 Cada semana
1/365 Cambiar aceite
Comprobar el nivel
Información general
movimientos involuntarios durante las tareas de
lubricación.
Si realiza la lubricación con una lata de aceite,
debe contener aceite de motor.
contrario, use grasa de bisulfuro de molibdeno de
grado alto.
dos veces por semana.
lubricación.
de correa. Si esto ocurre, intente limpiarlas
68
después de la limpieza, se debe reemplazar.
No se debe usar gasolina ni otros productos
derivados del petróleo para limpiar las correas.
INFORMACIÓN IMPORTANTE Utilice
polea de correa.
OPERATION
Safety section and following pages, if
Training
riding mowers.
prior to attempting to move the mower under its
until becoming comfortable with controls, use
a reduced throttle speed and reduced ground
furthest forward or reverse positions during initial
operation.
First time users must become familiar with the
mower's movement on a hard surface, such
to operate on turf. Until the operator becomes
comfortable with the mower controls and zero
Steering
To move forward and backward
control lever controls the right wheel.
Moving
Machine By Hand in the Operation section) to
its own power, the operator must sit in the seat
and start the engine (see Before Starting in the
Operation section). Adjust the engine speed to
inward. As long as the control levers have not
will not move.
neutral position and the mower will stop moving.
levers forward to the neutral position and mower
will stop moving.
To turn to the right
While moving in a forward direction, pull the right
maintaining the position of the left lever, this will
slow the rotation of the right wheel and cause the
machine to turn in that direction.
To turn to the left
While moving in a forward direction pull the left
maintaining the position of the right lever, this will
slow the rotation of the left wheel and cause the
machine to turn in that direction.
To zero turn
forward position and the other in the reverse
position, complete the turn.
Before Starting
1. Safety and Controls
before starting the machine.
2.
starting (see Maintenance Schedule in the
Maintenance section).
3.
4. Adjust the seat to the desired position.
IMPORTANT INFORMATION eat should
not be adjusted while the unit is in motion.
5.
pin into the desired cut height.
the engine can be started:
•
into the disengaged position.
•
position.
•
(outer) neutral position.
WARNING
rotating blades. Clear the lawn of stones and
other objects.
17