Air Filter; Fuel Filter - Maruyama BM240 Manual Del Propietario U Operador

When the throttle trigger is released, the engine should
return to an idle speed between 2700-3300 RPM, or
just below the clutch engagement speed. The Attached
Tool must not rotate/move and the engine should not
stall (stop running) at engine idle speed.
To adjust the engine idle speed, rotate the idle speed
adjustment screw on the carburetor.
Idle Speed Adjustment Screw
● Turn the idle speed screw in (clockwise) to increase
the engine idle speed.
● Turn the screw out (counter-clockwise) to decrease
the engine idle speed.
If idle speed adjustment is necessary, and after
adjustment the Attached Tool rotates/moves or the
engine stalls, stop using the Multi-Cutter immediately!
Contact your local authorized MARUYAMA Dealer for
assistance and servicing.

Air Filter

Maintenance Interval
● The air filter should be cleaned daily, or more often
when working in extremely dusty conditions.
● Replace after every 100 hours of operation.
Air Filter Cleaning
Air Filter Cover
Filter Screen
Foam Element
1. Loosen the knob and remove the air filter cover.
2. Remove the foam element and filter screen from
the air filter body.
3. Clean the foam element and filter screen with warm,
soapy water. Let the screen and element dry completely.
4. Apply a light coat of motor oil (SAE 30 or
equivalent viscosity) to the foam element and
squeeze out all excess oil.
5. Reassemble the filter screen and foam element to
the air filter body.
6. Reinstall the air filter cover and tighten the knob.

Fuel Filter

Maintenance Interval
● The fuel filter should be replaced after every 100
hours of operation.
● Fuel filters needing more frequent replacement may
indicate debris in fuel tank.
Fuel Filter Replacement
The fuel filter is attached to the end of the fuel pick-up
hose inside the fuel tank.
To replace the fuel filter:
1. Make sure the fuel tank is empty.
2. Remove the fuel cap.
3. Using a wire hook, gently pull the fuel filter out
through the fuel filler opening. Use caution not to
"fishhook" the fuel hose. Replace immediately if
punctured!
4. Grasp the fuel hose next to the fuel filter fitting
and remove the filter, but do not release the hose.
5. While still holding on to the fuel hose, attach the
new fuel filter.
6. Drop the new fuel filter back into the fuel tank.
7. Make sure that the fuel filter is not stuck in a
corner of the tank, and that the fuel hose is not
doubled over (kinked) before refueling.
— US-19 —
Fuel Pick-up Hose
Wire
Fuel Filter