Installation Instructions; Tools And Parts; Custom Overlay Panel - Kitchen Aid 2300275B Manual De Uso

Tools and Parts

TOOLS NEEDED:
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Hand drill or electric drill
(properly grounded)
¹⁄₂" Brad point doweling
drill bit
Phillips screwdriver
PARTS NEEDED:
Custom Overlay Door Panel—See "Overlay Panel—Rear View."
Hardware (Optional)
PARTS SUPPLIED:
Flat-head screws (8)
Round-head screws (8)

Custom Overlay Panel

If you plan to install a custom overlay panel, you will need to
create the panel yourself or consult a qualified cabinetmaker or
carpenter. See dimension drawings for panel specifications.
IMPORTANT:
The thickness of the wood overlay must be ³⁄₄" (1.91 cm).
Overlay panel must not weigh more than 20 lbs (9.07 kg).
Overlay panel weighing more than recommended may
cause damage to your refrigerator.
Overlay Panel—Rear View
Create the custom overlay panel using the dimensions shown.
¹³⁄₃₂
4 "
(11.2 cm)
⁵⁄₁₆
1 "
(3.33 cm)
A
⁵⁄₁₆
1 "
¹⁄₂
2 "
(3.33 cm)
(6.4 cm)
A. Overlay hook locations
4

INSTALLATION INSTRUCTIONS

Scissors
Masking tape
Tape measure
Petroleum jelly
Overlay plates (2)
Overlay hooks (4)
³⁄₄
23 "
(60.33 cm)
Install Overlay Hooks
Using a Phillips screwdriver and eight flat-head screws attach the
overlay hooks to the back of the overlay panel. See "Overlay
Panel–Rear View," for overlay hook locations.
Door Hinge Holes
The views of the top and bottom hinge pin hole show a right-
hand hinge. Mirror the image for a left-hand hinge.
We recommend using a C-Clamp and two pieces of scrap
wood (front and back) to help reinforce the overlay panel
when drilling the hinge pin holes.
1. Using a ¹⁄₂" Brad point doweling drill bit, drill a ¹⁄₂" (1.27 cm)
deep hole into the top of the overlay panel for the top hinge
pin as shown.
⁷⁄₈
29 "
(75.88 cm)
(1.35 mm)
2. Drill a ¹⁄₂" (1.27 cm) deep hole in the bottom of the overlay
panel for the bottom hinge pin as shown.
A. Overlay hooks (4)
Top View
¹⁄₂
"
(1.2 cm)
A
Front Surface
¹⁷⁄₃₂
"
Back Surface
A. Radius 5.0
A