Black and Decker HGS310 Manual Del Usario página 9

Vaporizador de mano profesional 2 en 1
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CLEANING FRAMES AND ACCESSORIES
For all accessories, allow to fully dry before using again or storing.
Accessories are not suitable for cleaning in a washing machine.
Lint frame: Wipe with damp cloth to clean.
Delicate frame: Wash with cold water and small amounts of gentle
cleanser if needed. The fabric in the frame cannot be removed.
Upholstery frame: The fabric on this frame can be removed and hand
washed with cold water and gentle cleanser.
Ironing pad: Spot treat as needed with cold water and gentle cleanser.
STORING THE STEAMER
1.
Check that the steamer is unplugged and completely cool.
2.
Gather the cord into even ovals and then gently cinch
with the strip of hook and loop. (Q)
3.
Always store steamer upright on its base to prevent
water leakage.
Tip: Emptying the tank after each use is recommended
because standing water can leave a residue over time.
STE AM ING TI P S A N D TR IC KS
This steamer is designed to use distilled, purified, or filtered water. Tap
water contains minerals that build up. Using water with perfumes or
scented additives is also not recommended.
Always test garments by steaming a small hidden area to make sure the
garment takes well to steam.
Always read garment care label instructions. Low heat settings require
the delicate fabric frame. Fabrics suitable for mid to high heat can be
pressed with the ironing plate.
Small amounts of dripping might occur during use. If excessive, either
the steamer needs time to get back up to full temperature or there
could be a build-up of condensation on the ironing plate. Just allow the
steamer a minute to reheat, or gently wipe the ironing plate against the
ironing pad fabric to remove condensation.
To prevent iron marks on fabric, turn garment inside out before using
the ironing plate. Sensitive items (such as items with embellishments)
should be steamed inside out as well to avoid damage.
Putting on clothes immediately after ironing or steaming can actually
create wrinkles. Always allow clothing to cool for about 5 minutes after
ironing or steaming to set the press.
9
Q

Publicidad

Tabla de contenido
loading

Tabla de contenido