Maintenance And Cleaning - Krampouz Diabolo Instrucciones De Uso

Cooking
Using the spreader:
1. Connect your crepe maker and position the thermostat slider at the desired temperature. Wait for
the light to go out (the thermostat automatically controls the heat throughout the use), then lightly
grease the hot plate and its guide groove with a cotton cloth dipped in oil.
Check the spreader is clean and let it soak in the water tray.
2. With one hand, fill the ladle right to the top. With the other, place the spreader facing towards
you in the groove of the hot plate
4. Leave the crepe to cook for approximately 10 to 15 seconds before turning it over. To do this,
slide the crepe turner gently under the edge of the crepe, turn your wrist and lift up the crepe
confidently, then turn it over onto the other side.
For crepes to be eaten cold, cook the other side only slightly.
For crepes to the filled, follow the instructions in the recipe book.
Wipe the hot plate and guide groove with the cloth, clean the spreader with the brush and put it in
the tray of water.
Tips
Always spread out the batter in a clockwise direction, never going backwards.
If required, apply gentle pressure to the spreader on the hot plate when rotating it.
Always make sure the batter has no lumps, sieve it if required.
To reheat crepes, use thermostat positions under 3.
Certain ready-made batters are not designed to be spread out with the spreader.
To ensure the coating of the hot plate has a long life expectancy, do not overgrease it and only use
wooden or plastic accessories.
You are advised to keep the original packaging to store the appliance and its accessories.

Maintenance and Cleaning

The non-stick hot plate does not require any specific maintenance. Simply wipe it with a dry cloth.
Avoid using chemical cleaning products and abrasive sponges on the non-stick hot plate.
. The frame and base can be cleaned with a damp sponge.
. Attention: Never wash this appliance in a lot of water. Disconnect it prior to cleaning it.
. If you have to replace the power supply cord, replace it with a cord of the same type H05RRF-3X0.75
fitted with a plug suitable for "hot conditions", the hot plate socket end.
3. Pour the whole ladle of batter into the spreader in one go
without trying to spread it out inside it and immediately
turn it clockwise. The first turn must be made in 2/3
seconds. Continue to rotate gently until the remaining
batter in the spreader is spread out then put it back in the
tray of water. You can also spread out this remaining
batter with the wooden rake.
-
- 11
,
2