GE Profile JVM1790 Serie Manual Del Propietário página 29

Remove 2 grille screws to remove
the grille.
Charcoal Filter
The charcoal filter cannot be cleaned. It must
be replaced. Order Part No. WB02X10943 from
your GE supplier.
If the model is not vented to the outside,
the air will be recirculated through a
disposable charcoal filter that helps
remove smoke and odors.
To Remove the Charcoal Filter
To remove the charcoal filter, first disconnect
power at the main fuse or circuit breaker,
or pull the plug. Remove the top grille
by removing the two screws that hold it
in place.
You may need to open the cabinet doors to
remove the screws.
To Install the Charcoal Filter
To install a new charcoal filter, remove
plastic and other outer wrapping from the
new filter.
Insert the top of the filter up and into the
grooves on the inside of the top opening.
Push the bottom of the filter in until it rests
in place behind the tabs.
The charcoal filter should be replaced
when it is noticeably dirty or discolored
(usually after 6 to 12 months, depending
on usage). See "Optional Kits," page 7,
for more information.
Lift the filter at the bottom until it
comes free of the tabs. Slide the filter
down and out.
ge.com
29