Connecting And Charging; Using Your Toothbrush - Braun Oral-B Triumph 4000 Manual Del Usuario

English
Description
a Brush head
b Pressure sensor light
c On/off button
d Brushing mode button
e Handle
f Brushing mode display
g Charge indicator
h Charging unit (basic charger and brush head
compartment with protective cover)

Connecting and charging

• Plug the charger into an electrical outlet. For
electric specifications, see printing on the charger.
• The flashing green lights indicate that the tooth-
brush is charging; once it is fully charged, the
lights turn off. A full charge enables approxi-
mately 10 days of regular brushing (twice a day,
2 minutes).
Note: If the green lights do not flash immediately,
continue charging. They will appear in 10–15
minutes.
• If the rechargeable battery is low the red low charge
indicator light is flashing for some seconds when
turning your toothbrush on/off. If the rechargeable
battery is empty the motor will stop; it will need
a 40-minute charge before you can use it for a
2-minute brushing.
• You can check the charging status for some
seconds by turning your toothbrush on/off or
placing it on the charging unit.

Using your toothbrush

Brushing technique
Wet brush head and apply toothpaste; you can use
any kind of toothpaste. To avoid splashing, guide
the brush head to your teeth before switching the
appliance on (c). Guide the brush head slowly from
tooth to tooth, spending a few seconds on each
tooth surface. Start brushing the outsides, and then
the insides and finally the chewing surfaces (picture
2, page 3). Brush all four quadrants of your mouth
equally.
In the first days of using any electric toothbrush,
your gums may bleed slightly. In general, bleeding
should stop after a few days. Should it persist after
2 weeks, please consult your dentist or dental
hygienist. If you have sensitive teeth and gums,
Oral-B recommends using the «Sensitive» mode
(optional in combination with the Oral-B Sensitive
brush head).
Professional Timer
The «Professional Timer» signals with short beep
sounds at 30-seconds intervals to move to the next
quadrant of your mouth (45 seconds intervals within
«Deep Clean» mode) (picture 2, page 3). A single
beep indicates completion of the first quadrant, two
beeps the second one, three beeps the third one
and four beeps sound when you reach the recom-
mended 2-minute brushing time.
The «Professional Timer» memorizes the elapsed
brushing time, even when the handle is briefly
switched off during brushing. The timer resets if
pausing longer than 30 seconds or briefly pressing
the mode button (d) during pause.
Pressure sensor
If you put excessive pressure on your teeth, the
red pressure sensor light (b) will light up (picture 2,
page 3). Additionally, when brushing in «Daily Clean»
or «Deep Clean» mode, the brushing mode will
change to the «Sensitive» mode. Periodically check
the operation of the pressure sensor by pressing
moderately on the brush head during use.
Brushing modes
Your toothbrush offers different brushing modes:
«Daily Clean» – Standard mode for daily
«Deep Clean» – Mouth cleaning with
«Sensitive» – Gentle, yet thorough cleaning
«Whitening» – Polishing for occasional or
Your toothbrush automatically starts in the «Daily
Clean» mode. To switch to the other modes, succes-
sively press the mode button (picture 3, page 3).
To return from any mode back to the «Daily Clean»
mode, press and hold the mode button. The brushing
mode is memorized even when the handle is briefly
switched off during brushing. When pausing longer
than 30 seconds or briefly pressing the mode button
(d) during pause the brushing mode resets to the
«Daily Clean» mode.
Brush heads
Oral-B offers you a variety of different brush heads
that fit your Oral-B Triumph toothbrush.
Oral-B FlossAction
features micropulse bristles that allow
for an outstanding plaque removal in
the interdental areas.
mouth cleaning
extended brushing time of
45 seconds per quadrant
(3 minute total brushing time)
for sensitive areas
everyday use
5