Installation Procedure For Windows Xp - Belkin F5U220ea Manual De Usuario

P73768ea-B_F5U220uk 17-03-2003 13:46 Page 13

Installation Procedure for Windows XP

This installation procedure will install two USB 1.1 OHCI controllers and
one USB 2.0 EHCI host controller.
Important Note: If you have already upgraded to Windows XP Service
Using the Windows XP Service Pack 1 Driver
1. Make sure your computer is completely powered down.
2. Remove the computer's cover and locate an empty PCI slot.
3. Remove the port cover that corresponds with the PCI slot you wish to
use. (The cover is usually held in place with a single screw.)
4. Insert the PCI Card into the slot. Apply pressure as needed until the
Card is fully seated. Secure the PCI Card with the screw removed in
step 3.
5. After installing the PCI Card, replace the outer cover and turn on the
computer.
Note: Depending on the speed of your computer, it may take up to 30-60
seconds for the PCI Card to be detected.
6. When Windows restarts, the PCI Card will be detected and drivers for
the two USB OHCI host controllers and the EHCI host controller will
be automatically installed. Installation is now complete.
INSTALLATION
Pack 1, support for your PCI Card is already installed on
your computer. If you have not upgraded to Windows XP
Service Pack 1, or if you wish to use the Belkin driver,
proceed to the "Installing Belkin Driver" section.
13
En