Makita UR101C Manual De Instrucciones página 18

When quitting the operation, press and hold the main
power button until the speed indicator goes off and then
perform the above procedure in reverse.
Correct handling of the tool
WARNING:
Always position the tool on your
right-hand side. Correct positioning of the tool allows
for maximum control and will reduce the risk of seri-
ous personal injury caused by kickback.
WARNING:
Be extremely careful to maintain
control of the tool at all times. Do not allow the tool
to be deflected toward you or anyone in the work
vicinity. Failure to keep control of the tool could result
in serious injury to the bystander and the operator.
WARNING:
To avoid accident, leave more than 15m
(50 ft) distance between operators when two or more oper-
ators work in one area. Also, arrange a person to observe
the distance between operators. If someone or an animal
enters the working area, immediately stop the operation.
CAUTION:
If the cutting tool accidentally
impacts a rock or hard object during operation,
stop the tool and inspect for any damage. If the
cutting tool is damaged, replace it immediately.
Use of a damaged cutting tool may result in serious
personal injury.
CAUTION:
Remove the blade cover from the
cutter blade when cutting the grass.
Correct positioning and handling allow optimum control
and reduce the risk of injury caused by kickback.
UR101C
C)+9?A
UR201C
When using a nylon cutting head (bump & feed
type)
The nylon cutting head is a dual string trimmer head
provided with a bump & feed mechanism.
To feed out the nylon cord, tap the cutting head against
the ground while rotating.
► 1. Most effective cutting area
NOTICE:
The bump feed will not operate prop-
erly if the nylon cutting head is not rotating.
NOTE: If the nylon cord does not feed out while
tapping the head, rewind/replace the nylon cord
by following the procedures in the section for the
maintenance.
Emergency detachment
CAUTION:
In case of emergency detachment,
pay extra attention to the position of the rotating
cutting tool.
In case of emergency, detach the tool in either way
described below:
Unlock the buckle on the waist belt and take off the
shoulder harness of the portable power pack which is
connected to the tool.
► 1. Buckle
18 ENGLISH
1
1