Double Insulation; Safety Instructions - Makita MLS100 Manual De Instrucciones

ENGLISH
SPECIFICATIONS
Model
Blade diameter
Hole diameter
Max. Miter angle
Max. Bevel angle
Max. Cutting capacities (H x W) with blade 255 mm in diameter
Bevel angle
0°
45° (left)
-1
No load speed (min )
Dimensions (L x W x H)
Net weight
Safety class
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･

DOUBLE INSULATION

･
To avoid injury from flying debris, keep
holding the saw head down, after
making cuts, until the blade has come
to a complete stop.
･
Do not place hand or fingers close to
the blade.
･
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
･
Always set SUB-FENCE to left position
when performing left bevel cuts. Failure
to do so may cause serious injury to
operator.
･
To loosen the bolt, turn it clockwise.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
75 mm x 130 mm
(2-15/16") X (5-1/8")
48 mm x 120 mm
(1-7/8") X (4-3/4")
END217-2
equipment and
Miter angle
0°
Intended use
The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.

SAFETY INSTRUCTIONS

WARNING! When using electric tools, basic safety
precautions, including the following, should always
be followed to reduce the risk of fire, electric shock
and personal injury. Read all these instructions
before operating this product and save these
instructions.
For safe operations:
1. Keep work area clean.
Cluttered areas and benches invite injuries.
its
2. Consider work area environment.
2
Left 45° , Right 45°
45° (left and right)
75 mm x 90 mm
(2-15/16") X (3-9/16")
48 mm x 90 mm
(1-7/8") X (3-9/16")
610 mm x 485 mm x 515 mm
(24" x 19-3/32" x 20-1/4")
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally
recycling facility.
MLS100
255 mm (10")
15.88 mm (5/8")
Left 45°
4,200
14.7 kg (32.3 lbs.)
/II
compatible
ENE004-1
ENF002-1
ENA001-2