Milwaukee Pro-Vac 8934 Manual Del Operador página 5

To reduce the risk of injury, wear safety goggles
or glasses with side shields. Unplug the tool
before changing
adjustments.
Never use this vacuum to pick up wet material.
Never operate vacuum
• without filter bag in place.
• without secondary filter in place.
• when the filter bag is full.
The vacuum comes fully assembled and ready for use.
Starting and Stopping Vacuum
To turn vacuum on, push the switch to the ON position.
To turn vacuum off, push the switch to the OFF position.
Changing Dust Bags (Figs. 1, 2 & 3)
1. Unplug vacuum cleaner.
2. Stand vacuum cleaner upright.
3. Remove tank by pulling up on the tank latch (Fig. 1).
Fig. 1
4. Remove filter bag by removing the cardboard collar from the intake port
(hold the bag upright to avoid spilling the contents) and discard.
If you are using the reusable cloth bag, shake the bag clean and
reattach.
5. Attach new filter bag to the intake port on the inside of the tank (Fig. 2).
Fig. 2
A
WARNING!
accessories or making
WARNING!
B C
OPERATION
6. Inspect secondary filter (shake or brush dirt from filter if necessary and
replace filter) (Fig. 3).
See "Secondary Filter" below.
Fig. 3
7. Reattach tank to lower half of the vacuum and snap the tank latch into
place.
Secondary Filter
Periodically brush or shake the secondary filter clean. If the filter is
excessively dirty, replace filter. If the secondary filter is excessively
dirty, there is either hole in the filter bag or the filter bag not being
securely attached to the intake port.
Attaching Accessories (Fig. 4)
1. Firmly push hose end into intake port
2. Twist the hose slightly to lock it in place
3. Firmly push the other end of the hose into accessory (wand, nozzle, or
other accessory) and twist it slightly to lock the hose and accessory
together.
Fig. 4
D
Page 5