Getting To Know Your Monitor; Lcd Display; Alarm Modes - Trust TOMY Digital Plus Manual De Instrucciones

• GETTING TO KNOW YOUR MONITOR

PARENT UNIT
Volume Control Wheel
On/Off Button
Nightlight On/Off Button
Timer Button
Microphone
Vibrate Alert Button
Sound Activation Button
Docking Station
Mains Cable Tidy
Timer Icon
Nightlight Icon
Vibrate Alert Icon
Sound Activation Icon
Sound Level Lights Display
BABY UNIT
Temperature Sensor
Timer Button
ON/OFF (& Pager) Button
Nightlight On/Off Button
Microphone
Timer Icon
Temperature Gauge
GB
Belt Clip
Attachment
2-Way Talkback
Button
Timer
Battery Icon
Temperature
Gauge
Movement
Sensor Pad
Display*

LCD Display

* See 'Accessories' section.
Timer
Battery Icon
LCD Display
2
• PARENT UNIT
Remove the battery compartment cover from the back of unit (N.B: this may already be supplied loose) and insert
the battery pack (supplied) correctly, connecting the plug with the socket. Replace the cover and screw firmly into
position, referring to the Quick Start Guide for pictorial reference.
Ensuring the power cable is correctly connected, place your Parent Unit into the Docking Station and charge for a full 6 hours.
You can use your monitor while it is charging by following the 'Set Up' guide below.
Important! Your Parent Unit will not function without first inserting the battery.
• BABY UNIT
For best performance we recommend that the Baby Unit is powered by your domestic mains supply using the power
adaptor supplied. Alternatively, you can use 4 x AA/LR6 batteries (not supplied) to make it fully portable. To insert the
batteries, unscrew the battery compartment cover on the underside of the unit using a flat-head screwdriver. Insert the
batteries, making sure you match the '+' and '-' polarity symbols. Replace the cover and screw firmly into position.
Position the Baby Unit at least 1 metre away from your baby ensuring all parts are kept out of reach. Under no
circumstance should you place any parts of the monitor in or on a cot. For best performance we recommend that the
monitor is placed no further away than 3 metres from your baby.
• SET UP
• POWER ON
Make sure both the Baby and Parent Units are plugged into the mains and/or have their batteries installed (see
above). The units should stand at least 1 metre apart.
Press and hold the button on each unit for at least 2 seconds. Once activated, the
• BABY AND PARENT UNIT CONNECTION
As each unit activates, watch for the animation sequence on the LCD
screens as the Baby and Parent Units auto-search and link to each other.
Once a connection is made between Baby and Parent Units, normal monitoring
will start. The above mentioned connection sequence is replaced on the LCD
screens on both units with the ambient temperature from the Baby Unit.

• ALARM MODES

Identify the cause of audible alarm by using the following table; should you be unable to identify or rectify the
cause of the problem, please refer to the Simple Solution Guide within this booklet.
Alarm tone on
Alarm Meaning
Parent Unit
Loss of contact.
••••••••
(Continuous)
Search Animation
Sequence Icon
Low Battery –
•••
Parent Unit
3 beeps
Low Battery –
••
Baby Unit
2 beeps
If the Vibrate Alert on the Parent Unit is switched ON (See 'Vibrate Alert' section within this booklet), the audible
alarm will be accompanied with a vibrating motion.
GB
buttons will glow.
Activation Sequence
Indications on the
Indications on the Parent Unit
Baby Unit
• Flashing search animation sequence. • Flashing search
animation sequence.
• The battery icon will flash.
• Button will change from
green to flashing red.
• The border of the battery icon will flash.
• Flashing battery icon.
• Button will change from green to
• Button will change
flashing red.
from green to flashing red.
3