Adjusting The Chains; Adjusting The Handlebar - Vermeiren Freedom Manual De Instrucciones

3.5

Adjusting the chains

3.6

Adjusting the handlebar

L
CAUTION:
Risk of injury – Check that the handlebar is firmly secure before
using the tricycle.
Adjusting angle:

1. Loosen the screw
2. Adjust the angle of the handlebar to a comfortable position (stepless).

3. Tighten the screw
.
properly.
Page 10
The wheels of the tricycle are driven by a
chain  on the rear axle.
For first time use the chains are set in the
factory. After a while it is possible that the
chains runs off the axle.
Tightening torpedo chain :
Loosen the nut . The torpedo system 
can now be moved on the frame of the
tricycle.
When the chain between the two chain-
wheels can be moved ± 20 mm, the chain
tension is correct.
Retighten the nut .
Tightening driving chain :
Loosen the nut . The wheel  can now be
moved upwards to tighten the chain .
When the chain between the two chain-
wheels can be moved ± 20 mm, the chain
tension is correct.
Retighten the nut .
The height and angle of the handlebar can
easily be adjusted.
Adjusting height:

1. Loosen the screw
2. A softly tap on the head of the cone.
3. Adjust the height of the handlebar to a
comfortable position (stepless --
depends on handlebar model).

4. Tighten the screw
2217, 2219
2015-03
.
properly.