Getting Started - Texas Instruments TI-5660 Manual De Instrucciones

Getting Started

Installing the Paper Roll
1. Remove the printer compartment cover.
2. Lift the paper holder so that it extends behind the printer
compartment.
3. Remove any packing materials from the printer compartment.
4. Replace the printer compartment cover.
5. Plug the calculator into an electrical outlet.
6. Set the power switch on the right side of the calculator to on
7. Place the paper roll on the paper holder.
8. Insert the end of the paper into the paper slot on the back of the
calculator as shown. To avoid paper jams, use quality bond paper.
9. While feeding the paper into the slot, press and hold &.
To prevent damaging the printer (which may void the warranty),
Note
move the PRINTER switch to OFF when operating the calculator without
paper.
Replacing the 2-Colour Ink Ribbon
1. Remove the paper roll and press & to run out any remaining paper.
2. Set the power switch on the right side of the calculator to off ( S ).
3. Remove the printer compartment cover.
4. Lift each ribbon spool until the ribbon is clear of the printer.
5. Lower the new ribbon (
and press down until it snaps into place.
red side on the bottom
1
( P )
) into the compartment
.