Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 1: PRELIMINARY INSTALLATION INSTRUCTIONS
A. Attach temporary supports "A" and "B" with 2 ½" deck screws as shown in Figure 4.
Support A
Support "A" should be located at the end where the door hinge of the ladder will go. The
edge of support "A" should extend into the rough opening 3/8" as shown in Figure 5. Make
sure both screws penetrate header above ceiling.
B. Measuring from the inside edge of support "A", locate and secure the inside edge of support
"B"
from inside edge of support "A" (Figure 5). Make sure both screws penetrate
header above ceiling.
Door hinge end
Frame
Header
C. Thread pull cord through pre–drilled hole in door and tie a knot in end of cord. Length can
be adjusted after ladder is completely installed. Be sure the knot is large enough to not slip
through the hole.
For aluminum models, remove aluminum feet on bottom section. These will be
5
Support B
FIGURE 6
Shim
Rough opening
FIGURE 7
STEP 1: PRELIMINARY INSTALLATION INSTRUCTIONS
A. Attach temporary supports "A" and "B" with 2 ½" deck screws as shown in Figure 4.
Support "A" should be located at the end where the door hinge of the ladder will go. The
edge of support "A" should extend into the rough opening 3/8" as shown in Figure 5. Make
sure both screws penetrate header above ceiling.
FIGURE 8: Wood series
B. Measuring from the inside edge of support "A", locate and secure the inside edge of support
"B"
from inside edge of support "A" (Figure 5). Make sure both screws penetrate
header above ceiling.
C. Thread pull cord through pre–drilled hole in door and tie a knot in end of cord. Length can
be adjusted after ladder is completely installed. Be sure the knot is large enough to not slip
through the hole.
For aluminum models, remove aluminum feet on
bottom section. These will be reinstalled in Step 3.
D. Position one person up in the attic, and position the other
person in the room below. When
using stepladder make sure ladder is fully open, all feet firmly
supported and user's weight and materials he is carrying does not
exceed the load rating of the ladder.
E. The person below will need to raise the attic ladder into the
rough opening and with
assistance from person above position securely on the temporary
FIGURE 10
FIGURE 9: Aluminum series
6
Publicidad
