Descargar Imprimir esta página

Louisville AA2210 Instrucciones De Instalación página 5

Ocultar thumbs Ver también para AA2210:

Publicidad

Idiomas disponibles

Idiomas disponibles

STEP 1: PRELIMINARY
INSTALLATION INSTRUCTIONS
A. Attach temporary supports "A" and "B" with 2 ½" deck
screws as shown in Figure 4.
Support "A" should be located at the end where the
door hinge of the ladder will go. The edge of support "A"
should extend into the rough opening 3/8" as shown in Figure 5. Make sure both screws
Measurement to floor
Subtract for rubber shoe
Rail cut length
penetrate header above ceiling.
B. Measuring from the inside edge of support "A", locate and secure the inside edge of support
"B"
from inside edge of support "A" (Figure 5). Make sure both screws penetrate
header above ceiling.
C. Thread pull cord through pre–drilled hole in door and tie a knot in end of cord. Length can
be adjusted after ladder is completely installed. Be sure the knot is large enough to not slip
through the hole.
7
FIGURE 11
LEFT RAIL
RIGHT RAIL
A
B
A
(-1/4")
(-1/4")
(-1/4")
TABLE 2
FIGURE 12
STEP 1: PRELIMINARY INSTALLATION INSTRUCTIONS
A. Attach temporary supports "A" and "B" with 2 ½" deck screws as shown in Figure 4.
Support "A" should be located at the end where the door hinge of the ladder will go. The
edge of support "A" should extend into the rough opening 3/8" as shown in Figure 5. Make
CEILING HEIGHT
7' 8" – 7' 9"*
7' 10" – 7' 11"
8' – 8' 2"
B
8' 3" – 8' 5"
8' 7" – 9' 1"
9' 2" – 9' 4"
(-1/4")
9' 5" – 9' 10"
9' 11" – 10' 3"
sure both screws penetrate header above ceiling.
B. Measuring from the inside edge of support "A", locate and secure the inside edge of support
"B"
from inside edge of support "A" (Figure 5). Make sure both screws penetrate
header above ceiling.
RAIL CUT
FOOT CUT
Figure 13, step #3
E
C
E
C
D
C
no cut
8' 6"
Figure 13, step #2
no cut
B
no cut
A
no cut
Figure 13, step #1
no cut
no cut
no cut
TABLE 3
Bottom section side rail
STEP 3:
STEP 2:
Cut not marked
Cut not marked
on rail
on rail
C
Aluminum feet
D
E
FIGURE 13
*7' 8" to 7' 9" ceiling
heights require
drilling mounting
holes. Use foot as
drilling template.
STEP 1:
Cut not marked
on rail
B
A
8

Publicidad

loading

Este manual también es adecuado para:

Aa2510Aa3010Wa2210